PPKIT03 - Power Probe III Tester - Master Combo Kit

Master Kit Includes: Complete PPLS01 Lead Set, ECT2000 Kit and a Complete Power Probe III Kit - The Master Technician Kit.

** VERY IMPORTANT NOTE: COMBO KITS AND MASTER KITS DO NOT OFFER COLOR CHOICE FOR POWER PROBE ** CASE IS RED **

** **

-------------------------------------------------------------------

Power Probe III

Maximum Voltage on Probe Tip: ± 200 Volts Relative to the Negative Battery Clip Probe tip resistance to ground 130KΩ Computer Safe: 0.1mA floating tip(warning: do not press power switch while connected to computer circuits with PP1,2 or 3)

Power Probe Mode (Mode 1)

DC Voltage Measurement: 0 to 70 Volts (in 1/10th increments)
AC Voltage Measurement: 0 to 70 Volts Peak to Peak
(See Peak to Peak & Threshold Setting Mode 5)

Square Wave Input Response: 15 Hz to over 500KHz
Sine Wave Input Response: 35 Hz to over 250KHz

Continuity to Ground: Greater than 20K Ohms - Display is Blank
Less than 20K Ohms: Display reads 0.0
Less than 2K Ohms: Display reads 0.0 and Green Led is On

Min (Mode 2) & Max (Mode 3)
Voltage Measurement: 0 to 70 Volts
Single Event Capture: Less than 200 Micro Second Pulse Width
Repetitive Events: Less than 1 Micro Second Pulse Width

Peak to Peak Mode (Mode 4)
0 to 70 Volts P-P
Square Wave Input Response: 4 Hz to over 500KHz
Sine Wave Input Response: 4 Hz to over 250KHz

Peak to Peak Mode Threshold Setting (Mode 5)
0.2, 0.5, 1, 2, 5, 10 & 50 When the Peak to Peak Voltage on
the Probe Tip exceeds this threshold then the display is
Peak to Peak AC rather than DC.

Storage temperature: -40°C (-40°F) to 70°C (158°F)
Operating temperature -20°C (-4°F) to 60°C (140°F)

Circuit Breaker
8 amp thermal response - manual reset 8 amp=No trip 10 amps=20 min. 15 amps=6 sec.
25 amps=2 sec. Short circuit=0.3 sec.